Genuine ASAHI pillow block 8mm bearing UCP08 / KP08 (K08+P08))

The miniature pillow block bearing KP08 is suitable for particularly small shaft diameters and high radial loads. The housing is made of zinc die-cast and sturdy.

Pillow blocks 8mm KP08
Technical specifications:
ID bearing (d): 8mm
Total length stock (L): 15mm
Housing length (F): 55mm
Housing width (H): 29mm
Hole spacing (E): 42mm
Bore diameter / mounting holes (K): 5mm

- onsisting of a ball bearing insert K08 and a zinc die-cast housing P08

- suitable for mounting on flat surfaces and high radial load capacities

- the housing is made of zinc die-cast

- the bearing insert has an extended inner ring with grub screws

- the pillow block bearing is mounted on the shaft with two grub screws

- the bearing insert can compensate for low static misalignment

- two-piece sealing system: with sheet steel washer reinforced rubber seal inside; outside additionally with upstream slinger made of sheet steel for high mechanical protection against foreign matter

- lubricated for life; under normal operating conditions relubrication is not required