Genuine ASAHI pillow block 8mm bearing UCP08 / KP08 (K08+P08))

ASAHI, Japan
ASAHI-UCP08
Out of stock
bearing
$4.79
The miniature pillow block bearing KP08 is suitable for particularly small shaft diameters and high radial loads. The housing is made of zinc die-cast and sturdy. Pillow blocks 8mm KP08Technical specifications:ID bearing (d): 8mmTotal length stock (L): 15mmHousing length (F): 55mmHousing width (H): 29mmHole spacing (E): 42mmBore diameter / mounting...
Terms & conditions

The miniature pillow block bearing KP08 is suitable for particularly small shaft diameters and high radial loads. The housing is made of zinc die-cast and sturdy.

Pillow blocks 8mm KP08
Technical specifications:
ID bearing (d): 8mm
Total length stock (L): 15mm
Housing length (F): 55mm
Housing width (H): 29mm
Hole spacing (E): 42mm
Bore diameter / mounting holes (K): 5mm

- onsisting of a ball bearing insert K08 and a zinc die-cast housing P08

- suitable for mounting on flat surfaces and high radial load capacities

- the housing is made of zinc die-cast

- the bearing insert has an extended inner ring with grub screws

- the pillow block bearing is mounted on the shaft with two grub screws

- the bearing insert can compensate for low static misalignment

- two-piece sealing system: with sheet steel washer reinforced rubber seal inside; outside additionally with upstream slinger made of sheet steel for high mechanical protection against foreign matter

- lubricated for life; under normal operating conditions relubrication is not required

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Genuine ASAHI pillow block 8mm bearing UCP08 / KP08 (K08+P08))
You have successfully subscribed!
This email has been registered
Newsletter
ico-collapse
0
Recently Viewed
ic-cross-line-top
Top
ic-expand
ic-cross-line-top